Ortofon Stylus 320

How to replace a stylus:

Firstly lock the turntable tone arm, unscrew the cartridge, gently remove the stylus from the cartridge body and insert a new stylus. A stylus is changed usually by pulling straight out and in the opposite direction of the turntable's arm. If the stylus doesn't come with direction, try these: with one hand, hold the cartridge to steady it. With the other hand grasp the stylus from both sides and pull. Install the new stylus. Holding the stylus from the top, press it gently into the space at the tip of the cartridge where the old stylus had been. Don't force it.

Technical specifications

Frequency response - 20-22.000 Hz
Tracking ability at 315Hz at recommended tracking force *) - 70 µm
Compliance, dynamic, lateral - 25 µm/mN
Stylus type - Elliptical Fine Line
Stylus tip radius - r/R 8/40 µm

*) Typical value

Equivalent stylus tip mass - 0,5 mg
Tracking force range - 1,25-17,5 g (12,5-17,5 mN)
Tracking force, recommended - 1,5 g (15 mN)
Tracking angle - 20°
Stylus colour - Grey

Recommended for  Series 300